Comme pour les coussinets et les bandes composites, SKF fabrique de série des rondelles de butée composites à partir de matériaux composites PTFE et POM. For additional information about the meaning and limitations of the product data, refer to SH bushings. Imprimer cette page; Partager. d, 35, mm. D, 60, mm. D1, 68, mm. L, 37, mm. L1, 49, mm. B, , mm. Calculation data. Max. torque, Mv, , N·m. Max. axial load, Pa, 41, kN. Mounting.

Author: Migor Tygoll
Country: Martinique
Language: English (Spanish)
Genre: Music
Published (Last): 12 July 2017
Pages: 240
PDF File Size: 11.90 Mb
ePub File Size: 15.85 Mb
ISBN: 912-4-28393-260-7
Downloads: 24763
Price: Free* [*Free Regsitration Required]
Uploader: Kalar

Joints à frottement mécanique, coussinets SH – SHT 70

To facilitate mounting FW busings, the bushing may be split lengthwise into two halves by using a diamond coated grinding wheel. SKF also recommends, particularly for larger bushings where more force is required that they be cooled before mounting. If composite plain bearings, for example strips, are to be located in a housing using an adhesive, the adhesive should be suitable for the expected operating temperature and should have suitable expansion, aging resistance, strength and curing properties.


When mounting, thrust washers should be positioned so that the steel backing abuts the housing wall.

The position of the lubrication groove of solid bronze bushings depends on whether it is an oscillating or rotating or movement and, for the latter, sif oil or grease lubrication is applied fig.

In addition, cleanliness, and understanding the causes of premature bearing failure can help too. If no operational experience is available, SKF recommends contacting an adhesive manufacturer for advice.

Imprimer cette page Partager Partager cette page. Check also the shaft for sharp edges, burrs or surface defects, couzsinets could damage the sliding surface of the bushings.

Sufficient cooling fluid should be applied as well to avoid excessive temperatures, as they can destroy the bushing. Check that the counter surface shaft seat and other components such as the housing are clean, deburred and that they do not contain any abrasive particles.

When applying an adhesive, care should be coussinefs so that no adhesive reaches the sliding surface. SKF sintered bronze bushings are impregnated with a lubricant and.

Once all coussintes components have been cleaned and checked, the bushing is ready to be installed. Mounting Skill and care in mounting are prerequisites for long bearing service life. For larger bushings, SKF recommends using a mounting ring fig.


Coussinets – PBMF M1

Care should always be taken when mounting FW bushings not to damage the sliding layer or side faces. Otherwise when the bushing comes in contact with absorbent material it may wick the oil away very quickly. To do this, place an O-ring on the dolly to keep the bushing in position. Then drive the bushing into place with a mechanical or hydraulic press or by tapping the dolly lightly with a hammer.

To facilitate the mounting of small bushings, apply a light coating of oil or grease to the housing bore. To install bushings, with or without a flange, SKF recommends using a mounting dolly particularly for composite fig.